Order your BBBmini DIY Linux autopilot Kit

copter antenna-trackerplanerover

  • APM/ArduPilot is the leading open source unmanned aerial vehicle (UAV) plattform (GPL v3 licensed).
  • Linux is the most popular open source operating system
  • BBBmini DIY Kit is the fastest way to build your DIY Linux autopilot.

This pack is a great way to start and will let you connect your Autopilot to the net.

If you like the idea of flying with Linux, get your Kit now!

BBBmini Rev. 1.5 PCB
BBBmini Rev. 1.5 PCB
  • All parts including Rev 1.5 PCB and headers included to get you started.
  • Quick to assemble and use
  • Plugs into any breadboard, or you can use wires
  • Compatible will all ArduPilot vehicle types: (ArduPlane, ArduCopter and APMrover2, AntennaTracker)
  • MPU-9250 10DOF IMU
  • Digital High accuracy Barometer
  • PPM and SBUS input, 12 RC_OUT PWM Channels
  • UART4 & UART5 port
  • CAN Bus interface
  • Voltage and current sensing support via power-module (additional item).
  • External SPI Bus connector for additional hardware
  • External I2C Bus connector for additional hardware.
  • Additional ESC out connectors for X-Quad configuration.
  • Dedicated HC-SR04 Ultrasonic Range Finder connector
  • No need to worry about level shifters or power.
  • Breadboard Friendly
  • Expandable, Flexible

Included Parts

  1. BBBMINI-PCB Rev 1.5
  2. All needed Hardware included
  3. 2 x Sensor breakeout board (MPU9250 & MS5611)
  4. Can Transceiver
  5. Capacitors and resistors
  6. Sonar Sensor & Mounting Bracket
  7. Powermodule XT 60
  8. OLED Display
  9. Cables for peripherals

BBBmini DIY KIT

*Parts may vary from photo*

Pricing

  • The BBBMINI is a kit and requires some light soldering which should only take about 30 minutes. It  is Available for (pre-)order at 80€ including shipping worldwide.

free-shipping-

Currently we have 0 in stock (can be backordered)

 

Sold Out – More coming in April 2017

 

THIS KIT DOES NOT INCLUDE A BEAGLEBONE BLACK.

Tools and Materials required for assembly

Safety glasses, Soldering Station or iron, Solder, Flux, Digital Multimeter, Phillips screwdriver, Helping hands (recommended)

Electronics

BeagleBone Black (Rev C) , 8GB Class 10 sdcard (get one from SanDisk), 5V UBEC, 3.3V GPS

 

NOTE: Recipients are responsible for any additional charges for customs clearance.
The possibility and amount of customs is dependent on the destination country.

PayPal payments are subject to a 2% (Germany) or 4% (outside of Germany) transaction fee.  For customers in the EU we recommend the IBAN bank transfer. For customers outside the EU PayPal is recommended.

Linux is a registered trademark of Linus Torvalds.